Problem with N07 - Kingston NVME not found, LED not lighting up
-
Hi,
I bought the N07 board and installed it according to the manual. The pogo pins are lining up perfectly and the ribbon cable is attached properly.
I bought a new Kingston NV2 NVMe M.2 ssd 1TB (pretty much the same ssd that is shown on the pictures on the product side, only 1 TB instead of 256GB).
The blue LED on the N07 board only lights up for a splitsecond after the power cable is attached to the raspberry pi and stays out afterwards.
The SSD is not found in a fresh installed rpi os. Neither lsblk or lspci shows the device.
If I search the log messages with dmesg | grep pci
[ 0.387295] brcm-pcie 1000110000.pcie: host bridge /axi/pcie@110000 ranges:
[ 0.387302] brcm-pcie 1000110000.pcie: No bus range found for /axi/pcie@110000, using [bus 00-ff]
[ 0.387313] brcm-pcie 1000110000.pcie: MEM 0x1b00000000..0x1bfffffffb -> 0x0000000000
[ 0.387319] brcm-pcie 1000110000.pcie: MEM 0x1800000000..0x1affffffff -> 0x0400000000
[ 0.387326] brcm-pcie 1000110000.pcie: IB MEM 0x0000000000..0x0fffffffff -> 0x1000000000
[ 0.388681] brcm-pcie 1000110000.pcie: Forcing gen 2
[ 0.388850] brcm-pcie 1000110000.pcie: PCI host bridge to bus 0000:00
[ 0.388854] pci_bus 0000:00: root bus resource [bus 00-ff]
[ 0.388858] pci_bus 0000:00: root bus resource [mem 0x1b00000000-0x1bfffffffb] (bus address [0x00000000-0xfffffffb])
[ 0.388861] pci_bus 0000:00: root bus resource [mem 0x1800000000-0x1affffffff pref] (bus address [0x400000000-0x6ffffffff])
[ 0.388874] pci 0000:00:00.0: [14e4:2712] type 01 class 0x060400
[ 0.388902] pci 0000:00:00.0: PME# supported from D0 D3hot
[ 0.389827] pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring
[ 0.817807] brcm-pcie 1000110000.pcie: link down